Wall mounted Fiber optic Rack for front mounted equipmen. It is produced in aluminium ensuring low weight and simple transport. It has profiles with slide rails that allows continuous height adjustment of nut and screw when installing equipment. Delivered flat-packed, so that one person can easily carry and mount the rack alone. Flexi Rack ETSI, B600xH2740xD400, wall mounted.
The Flexi Rack series is available in 19" design in standard heights 1800, 2000 and 2200 mm. Other widths and heights, as well as ETSI section width, can be supplied on request. The Flexi Rack series can also be supplied with side organizers for optimal fiber patch routing. The racks series offer high termination capacity.
- For wall-mounting
- Aluminum frames
- With 1 section, 550 mm
- Accessories available: cable trays, guide bars etc.
Cable ladder used for fastening cables and tubes to the rack.
Cable ladder used for fastening cables and tubes to the rack.
Shelf for network equipment that cannot be screwed directly into data or fiber rack or cabinet. The shelf has holes for better ventilation.
Shelf for network equipment that cannot be screwed directly into data or fiber rack or cabinet. The shelf has holes for better ventilation.
Shelf retractable for network equipment that cannot be screwed directly into data or fiber rack or cabinet. The shelf has holes for better ventilation.
Screw with spring nut for FR racks. The spring nut can be adjusted continuously height-wise in the rack.
Bend limiter for avoiding sharp bends on fiber optic patch cords in rack. Bend diameter 30 mmÂ
Bend limiter for avoiding sharp bends on fiber optic patch cords in rack.
Guide to be placed in the middle of the vertical cord guide to keep the patch cords together.
Large brackets for sliding equipment onto. Fasten one on each sidewall in the racket. Â
Routing guide used on fan-out units to avoid that weight creates sharp bends or cord stress, may also be used to separate some patch cords from the rest.
Cable distributor used to separate the fibre-tubes in large cables to terminate them in different fiber optic panels.
Bend limiter for mounting on the top of the rack. Offload patch cords which must be guided over the top.
Angled bracket for mounting cable ladders and other equipment in racks.
Recently viewed
Wall mounted Fiber optic Rack for front mounted equipmen. It is produced in aluminium ensuring low weight and simple transport. It has profiles with slide rails that allows continuous height adjustment of nut and screw when installing equipment. Delivered flat-packed, so that one person can easily carry and mount the rack alone. Flexi Rack ETSI, B600xH2740xD400, wall mounted.